System Architecture |
Full-sized SBC with PCI/ISA Golden finger
PICMG 1.3 Compliant |
CPU Support |
Single socket LGA775
Support Intel® Pentium 4 with 533/800 MHz FSB, speed up to 3.8GHz.
Supports Intel Celeron D with 533 MHz FSB
Supports Intel Pentium D with 800 MHz FSB
Support Hyper-Threading Technology |
System Memory |
2 x 240-pin DIMM
Dual channel Non-ECC DDR2 400/533 MHz SDRAM, up to 2 GB |
BIOS |
Award System BIOS
Plug & Play support
Advanced Power Management and Advanced Configuration & Power Interface support |
Chipsets |
Intel®945G and ICH7 chipset |
LAN |
RC82573L PCI Express Gigabit Ethernet LAN x 2
Supports Boot from LAN |
Display |
Chipset with built-in integrated graphics device
Analog display support up to 2048 x 1536 @ 85 Hz for CRT |
I/O Interface |
- COM port x 2 with 10-pin headers(COM 2 reserved for RS422/RS485 as option)
- USB 2.0 ports x 8 (4 on board, 4 to backplane), bandwidth: 480 Mb/s
- Ultra ATA 100/66/33, 40-pin connector x 1
- Disk on Module: 2-pin power connector for DOM
- SATA HDD: 4 serial ATA ports, bandwidth: 150 MB/s , Support RAID 0.1
- Parallel port: 26-pin connector x 1
- Floppy: 34-pin connector x 1
- AC’ 97 Audio Codec, Realtek ALC655
- GPIO: Supports 4 sets general purpose I/O each with TTL level (5 V) interface
- I/O On bracket 2.5
- VGA DB-15 connector x 1
- RJ45 Gigabit Ethernet LAN port x 2
- PS/2 Keyboard/Mouse x 1
- On-board buzzer x 1
- 2-pin power on button switch
- SMBus 2.0 controller (2-pin header) to backplane
- On-board 2-pin header for reset
- 4-pin for speaker
- 5-pin for key lock/power LED/HDD Power LED
- 4-pin fan JST connector x 1 (for CPU); 3-pin fan connector x 2
- 5-pin connector x 1 for chassis or backplane front Keyboard/Mouse
|
Watchdog Timer |
1-minute increments from 1 to 255 minutes, 1-second increments from 1 to 255 seconds |
On-board RTC |
On-chip RTC with battery backup
External Li battery x 1 |
Disk On Module |
2-pin power connector for DOM |
System Monitor |
System monitor controller from Super I/O.
8 voltages (For +1.5 V, +3.3 V, +5 V, -5 V, +12 V, -12 V, Vcore and +5 Vsb).
2 temperature (For CPU and system),
3 fan speed monitors (one for CPU and two for systems) |
Power Input |
Power source from backplane through golden finger
Supports both ATX or BTX power supplies
4-pin +12 V power input connector |
Power Requirements |
Maximum designed power based on Pentium 4 3.8 GHz CPU
5 V: 18 A; 12 V: 20 A; 3.3 V: 5 A; 5 Vsb: 2 A |
Dimensions |
338.58 mm (L) x 126.39 mm (W) |
Environment |
Board level operating temperature: 0°C to 60°C
Storage temperature: -20°C to 80°C
Relative humidity: 10% to 90% (Non-condensing) |
Certification |
CE approval, FCC Class A |
